Table of Contents
Advertisement
Setup
Operating Instructions 195 - 01.0 - 11/2017
Fig. 48: Assembling the pedal and setpoint device (2)
③
④
⑤
(3) - Bracket
(4) - Setpoint device
(5) - Ball joints
3.
Screw the bracket (3) under the tabletop so that the pedal
rod (7) runs to the pedal (1) in alignment with the setpoint
device (4).
4.
Screw the setpoint device (4) onto the bracket (3).
5.
Attach the pedal rod (7) with the ball joints (5) to the setpoint
device (4) and to the pedal (1).
6.
Slightly loosen the 2 screws (6).
Fig. 49: Assembling the pedal and setpoint device (3)
7.
Pull the pedal rod (7) to the correct length:
Proper setting: 10° inclination with pedal (1) released
8.
Tighten both screws (6).
The pedal (1) and the setpoint device (4) have been fully
assembled.
(6) - Screw (only the 1st one is visible)
(7) - Pedal rod
10°
①
⑦
⑥
73
Advertisement
Table of Contents
