Assembly; Assembly Of Sleeping Platform; Attaching The End Frames To The Sleeping Platform - Park House Healthcare Tudor User Manual

4

Assembly

4.1 Assembly of the sleeping platform
Slide the side frames together as indicated in the diagram.
Ensure both frames fit fully together until the outer tubes touch each other and the holes in the bed frame match up
with the hole in the connecting bar.
Insert the lock-pins and tighten the hand-screws on the underside on each side of the side frames. Do not over
tighten.

4.2 Attaching the end frames to the sleeping platform

Firstly identify the head and foot ends of the sleeping platform. The head end has one mesh section and foot end
has two sections.
IMPORTANT - The head and foot frames MUST be fitted to the correct ends of the sleeping platform.
IMPORTANT - Please make sure that for normal use, the longer T bracket is fully inserted into the side
frame before inserting the lock-pins. The second set of fixings are only to be used to extend the bed
length, when an extension panel must be used.
Head frame
Ensure the T bracket of the head frame fits fully into the side frame of the sleeping platform.
Check that the holes in the side frame match up to the holes in the T brackets, before inserting the lock-pins.
Tighten all hand-screws on the underside of the side frames. Do not over tighten.
4
Foot frame