Configuration - GEZE Perlan AUT-NT Wiring Diagram

GEZE Perlan AUT-NT
à Speed (6 to 8)
The speed has to be set on the basis of the leaf weight.
à (6) Leaf weight 80 kg–60 kg (approx. 70% of the maximum speed)
à (7) Leaf weight 60 kg–40 kg (approx. 85% of the maximum speed)
à (8) Leaf weight 40 kg–20 kg (approx. 100% of the maximum speed)
à If no or several switches are activated for the speed, moving is only carried out at the reduced speed (ap-
prox. 20% of the maximum speed).
Hold-open time
In automatic mode the hold-open time defines how long the sliding door drive waits after an open command
until it closes automatically.
If the potentiometer is positioned at the right-hand stop, the hold-open time amounts to 30 seconds.
If the potentiometer is positioned at the left-hand stop, the hold-open time amounts to 5 seconds.
17. 1

Configuration

The controller is configured at Potentiometer P1 as well as at the DIP switches. The function of the individual ele-
ments is explained below.
The controller does not accept the settings of the configuration until after the change into configuration mode
and subsequent exiting of the configuration mode.
Configuring before the first commissioning
Set the desired configuration in a deenergized state.
X
Carry out commissioning (see Chapter 17).
X
The set configuration is accepted during commissioning.
Configuring during operation
à Controller is already ready. First commissioning has been carried out.
à Power supply connected, no LED lights up.
Press the Reset button for approx. 2 seconds.
X
The red LED begins to flash continuously.
Set the desired configuration.
X
Press the Reset button briefly (less than half a second).
X
Controller is already in the starting state:
The red LED flashes twice consecutively with approx. 1.5 seconds break continuously.
Carry out a movement.
X
Sliding door drive moves in creep mode.
The red LED extinguishes.
The new configuration has been accepted.
Commissioning and service
0.20 m/s
0.23 m/s
0.28 m/s
17