Sony SRP-X500P Interface Manual page 26

♦ PROJECTOR PROTOCOL SWITCH (1st byte)
SYSTEM TYPE SWITCH (2nd byte)
Shows the position of the PROJECTOR PROTOCOL selector or the SYSTEM TYPE selector on the
front panel of the SRP-X500P.
The parameters and the switch position are shown in the following table.
SWITCH
0 0x30 ('0')
1 0x31 ('1')
2 0x32 ('2')
3 0x33 ('3')
4 0x34 ('4')
5 0x35 ('5')
6 0x36 ('6')
7 0x37 ('7')
8 0x38 ('8')
9 0x39 ('9')
A 0x3A (':')
B 0x3B (';')
C 0x3C ('<')
D 0x3D ('=')
E 0x3E ('>')
F 0x3F ('?')
♦ INPUT VOLUME (3rd-8th byte)
Shows the setting of the input level controls on the front panel of the SRP-X500P.
Byte Parameter
1st MIC 1/WL 1 INPUT VOLUME
2nd MIC 2/WL 2 INPUT VOLUME
3rd MIC 3 INPUT VOLUME
4th MIC 4 INPUT VOLUME
5th LINE INPUT VOLUME
6th AV/RGB INPUT VOLUME
The correspondence of the parameter with the level setting is the same as that of the FADER
parameter of the INPUT FADER command (page 7).
♦ MASTER VOLUME LEVEL (9th byte)
Shows the setting of the MASTER control on the front panel of the SRP-X500P.
The correspondence of the parameter with the level setting is the same as that of the FADER
parameter of the INPUT FADER command (page 7).
♦ REMOTE 1-6 LEVEL (10th-15th byte)
Shows the level of the REMOTE 1-6 faders.
The correspondence of the parameter with the level setting is the same as that of the LEVEL
parameter of the REMOTE 1-6 LEVEL command (page 10).
SRP-X500P RS-232C Interface Manual
Page 26/43