Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Hach Pocket Pro Salinity
Summary of Contents for Hach Pocket Pro Salinity
- Page 1 User Manual DOC022.52.80400 ™ Pocket Pro Salinity...
-
Page 2: Specifications
Specifications Specifications are subject to change without notice. Specification Details Dimensions (W x D x H) 37 x 30 x 170 mm (1.45 x 1.18 x 6.69 in.) Enclosure rating IP67 Weight 135 g (0.297 lb) with batteries Power requirements (internal) AAA alkaline batteries (4x) Battery life 450 hours... -
Page 3: Precautionary Labels
W A R N I N G Indicates a potentially or imminently hazardous situation which, if not avoided, could result in death or serious injury. C A U T I O N Indicates a potentially hazardous situation that may result in minor or moderate injury. N O T I C E Indicates a situation which, if not avoided, may cause damage to the instrument. -
Page 4: Product Overview
1. Move the equipment away from the device receiving the interference. 2. Reposition the receiving antenna for the device receiving the interference. 3. Try combinations of the above. Product overview ™ The Pocket Pro salinity tester measures the salinity of general water samples. Refer to Figure 1. -
Page 5: Install The Batteries
Figure 2 Product components 1 Pocket Pro tester 3 Lanyard ™ 2 AAA alkaline batteries (4x) 4 SINGLET (12.88 mS/cm) Install the batteries C A U T I O N Explosion hazard. Incorrect battery installation can cause the release of explosive gases. Be sure that the batteries are of the same approved chemical type and are inserted in the correct orientation. -
Page 6: Keypad Description
Figure 4 Display overview 1 Calibration icon 4 Battery icon 7 Calibration standard expected 2 Lock icon 5 Parameter value 8 Temperature 3 Parameter 6 Calibration standard measured for last calibration (high) Table 1 Display icons Icon Description Shows the battery power level. Flashes when the battery power is less than 10%. Shows when the lock feature is on. - Page 7 Table 2 Key functions Description Push and hold to set the power to on or off. Push to start a calibration. To exit a calibration, push and hold. Push and hold until "SEt" shows on the display to go to the settings menu. To exit the settings menu, push and hold until "End"...
-
Page 8: Advanced Operation
7. To keep the measured value on the display when the sensor is removed from the sample, push . Note: The lock icon shows on the display when the measurement is stable. 8. To measure another sample, do steps 3–7. 9. -
Page 9: Replace The Batteries
Replace the batteries When the battery icon flashes or the tester will not come on, replace all four batteries. Refer to Install the batteries on page 5. Troubleshooting Message Possible cause Solution "- - - -" The parameter value is not within the Make sure that the value of the sample is within the measurement range of the tester. - Page 10 Tel. +49 (0) 2 11 52 88-320 SWITZERLAND Fax (970) 669-2932 Fax +49 (0) 2 11 52 88-210 Tel. +41 22 594 6400 orders@hach.com info@hach-lange.de Fax +41 22 594 6499 www.hach.com www.hach-lange.de © Hach Company/Hach Lange GmbH, 2014. All rights reserved. 12/2014, Edition 2...
Need help?
Do you have a question about the Pocket Pro Salinity and is the answer not in the manual?
Questions and answers