Hach Pocket Pro+ Multi 1 - Tester for Cond/TDS/Salinity Manual

Introduction

This multi-parameter tester is for use in general water samples.

Explosion hazard. Incorrect battery installation can cause the release of explosive gases. Be sure that the batteries are of the same approved chemical type and are inserted in the correct orientation. Do not mix new and used batteries.
Fire hazard. Battery substitution is not permitted. Use only alkaline batteries.

Chemical exposure hazard. Refer to the current material safety data sheets (MSDS) for safety protocols.

Keys

Push and hold to change the parameter selected. Push to stop changes to the display.

Push to do a calibration. Push and hold until "SEt" flashes to go to the settings menu. Then, push to scroll through the settings.
To exit, push and hold.

Note:
Power cannot be set to off while in settings or calibration mode.

Calibration

For 2 or 3-point calibration: do calibration two or three times with different standards.

Measurement

For best results, use the sensor cap. One parameter can be measured at a time.

Storage

Refer to the expanded user manual on the manufacturer's website.

Settings

Warranty

1 year for tester body and sensor for manufacturing defects only. Damage from use is not covered.

Compliance

Refer to the expanded user manual on the manufacturer's website.