Replace the batteries
Troubleshooting
Message
"- - - -"
The parameter value is not within the
measurement range of the tester. Refer to
(top line)
Specifications
"- - - -"
The temperature value is not within the
operating temperature range of the tester or
(bottom line)
a temperature sensor failure occurred. Refer
to
Specifications
temperature range.
Battery icon flashes The batteries have less than 10% power
remaining.
Replacement parts
Description
AAA alkaline batteries
Lanyard
SINGLET, 12.88 mS/cm
When the battery icon flashes or the tester will not come on, replace all four batteries.
Refer to
Install the batteries
Possible cause
on page 2.
on page 2 for the operating
Personal injury hazard. Use of non-approved parts may cause personal injury, damage to
the instrument or equipment malfunction. The replacement parts in this section are
approved by the manufacturer.
Note: Product and Article numbers may vary for some selling regions. Contact the appropriate
distributor or refer to the company website for contact information.
Table 4 Replacement parts
on page 5.
Make sure that the value of the sample is within the
measurement range of the tester. Gently clean the
sensor. Refer to
as necessary.
Make sure that the sample temperature is within the
operating temperature range of the tester. Contact
technical support as necessary.
Note: The tester can still be used if a temperature sensor failure
has occurred, but without automatic temperature compensation.
Replace all four batteries. Refer to
on page 5.
W A R N I N G
Solution
Clean the sensor
on page 8. Calibrate
Install the batteries
Quantity
4/pkg
4674300
1
20/pkg
2771520
Item no.
201305
9