Silvercrest SHTR 2200 E3 Operating Instructions Manual page 7

Hide thumbs Also See for SHTR 2200 E3:
Table of Contents

Advertisement

Available languages

Available languages

__NAS278227_Haartrockner_B7.book Seite 5 Mittwoch, 28. September 2016 10:34 10
DANGER! Risk of electric
shock due to moisture
Do not use this device in the vi-
cinity of bathtubs, showers,
washbasins or other vessels
containing water.
Never place the device anywhere that it
could fall into water while plugged in.
Protect the device from moisture, water
drops and water spray.
The device, the cable and the mains
plug must not be immersed in water or
any other liquids.
If liquid gets into the device, remove the
mains plug immediately. Have the de-
vice checked before reusing.
If the device has fallen into water, pull
out the mains plug immediately, and
only then remove the device from the
water. Do not use the device again, and
have it checked by a specialist.
Never touch the device with wet hands.
DANGER! Risk of electric
shock
Do not use the device if the device or
the power cable has any visible dam-
age, or if the device has previously
been dropped.
Lay the power cable such that no one can
step on it, get caught on it, or trip over it.
Only connect the mains plug to a proper-
ly installed and easily accessible wall
socket whose voltage corresponds to the
specifications on the rating plate. The
wall socket must continue to be easily ac-
cessible after the device is plugged in.
Ensure that the power cable cannot be
damaged by sharp edges or hot points.
Do not wrap the power cable around
the device (risk of cable damage!).
Ensure that the power cable cannot be
trapped or crushed.
To pull the mains plug out of the wall
socket, always pull on the mains plug,
and never on the power cable.
Disconnect the mains plug from the wall
socket...
... after every use,
... if there is a fault,
... when you are not using the device,
... before you clean the device, and
... during thunderstorms.
To avoid any risk, do not make modifi-
cations to the product. You also must not
replace the power cable yourself. Re-
pairs must be carried out by a specialist
workshop or the Service Centre.
Never attempt to remove dust or foreign
bodies from inside the device using a
pointed object (e.g. with a tail comb).
DANGER! Fire hazard
Never leave the device unattended
while it is plugged in.
Never cover the device or place it on
soft objects (e.g. towels).
Ensure that the air inlet and outlet are al-
ways kept free. Keep the air inlet away
from long hair or objects that could get
sucked in.
This appliance is protected against over-
heating. In the event of overheating,
e.g. because the air inlet or outlet is
covered, the device switches off auto-
matically. In this case, set the on/off
switch to 0 (off), pull the mains plug out
of the wall socket and allow the device
to cool down adequately. Ensure that no
hair or foreign bodies are blocking the
air inlet before switching the device
back on.
Never switch on the device at the same
time as there is another device with a
high power consumption attached to the
same multi-socket power strip.
Do not use an extension cable.
5
GB

Advertisement

Chapters

Table of Contents
loading

Table of Contents