Command Quick Reference - Agilent Technologies HP E1355A User Manual

Command Quick Reference

Command
Subsystem
ABORt ABORt
ARM :COUNt <number> [MIN | MAX]
:COUNt? [MIN | MAX]
CALibration :STRain <channel_list>
CONFigure :STRain[:<strain_function>] <channel_list>
DISPlay :MONitor:CARD <number> | AUTO
:MONitor[:STATe] <mode>
INITiate :CONTinuous <mode>
:CONTinuous?
[:IMMediate]
MEASure :STRain[:<strain_function>]? <channel_list>
OUTPut [:STATe] <mode>
[:STATe]?
[ROUTe:] CLOSe <channel_list>
CLOSe? <channel_list>
OPEN <channel_list>
OPEN? <channel_list>
SCAN <channel_list>
SCAN:MODE <mode>
SCAN:MODE?
SCAN:PORT <port>
SCAN:PORT?
SETTling[:TIME] <time>,<channel_list>
SETTling:TIME? [MIN | MAX],<channel_list>
[SENSe:] STRain:GFACtor<gage_factor>,<channel_list>
STRain:GFACtor? <channel_list>
STRain:POISson <poisson_ratio>,<channel_list>
STRain:POISson? <channel_list>
STRain:UNSTrained <reference>,<channel>
STRain:UNSTrained? <channel_list>
STATus :OPERation:ENABle <number>
:OPERation[:EVENt]?
SYSTem :CDEScription? <number>
:CPON <number> | ALL
:CTYPe? <number>
:ERRor?
Chapter 5
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
The following tables summarize SCPI and IEEE 488.2 Common (*)
Commands for the Relay and FET Strain Gage Multiplexers.
SCPI Commands Quick Reference
Command/Parameter
Continued on Next Page
Strain Gage Multiplexer Command Reference
Description
Abort a scan in progress.
Multiple scans per INIT command.
Query number of scans.
Multimeter command - measures the unstrained
reference voltage on the strain measurement channel
specified.
Multimeter command - configures the multimeter for
strain measurements.
Selects module to be monitored.
Selects monitor mode.
Enables/Disables continuous scanning.
Queries scanning state.
Starts a scanning cycle.
Multimeter command - configures the multimeter and
makes the specified strain measurement.
Enables/Disables "Trig Out" pulse.
Queries state of "Trig Out" port.
Close channel(s).
Query channel(s) closed.
Open channel(s).
Query channel(s) opened.
Define channels for scanning.
Selects appropriate tree isolation switches for
measurements.
Returns present state of scan mode.
Enables tree isolation switches closure as part of a
measurement.
Query analog bus state.
Sets delay between trigger pulse and channel closed
pulse.
Returns current parameter in SETTling:TIME.
Specifies the gage factor for the strain channel.
Queries the gage factor.
Specifies the Poisson ratio for the strain channel.
Queries the Poisson ratio.
Downloads the unstrained reference voltage.
Queries the unstrained reference voltages.
Enables the Operation Status Register to set a bit in
the Status Register.
Returns status of Operation Status Register.
Returns description of module in a switchbox.
Sets specified module to its power-on state.
Returns the module type.
Returns error number/message in a switchbox to error
queue.
99