Output; [:State] - Agilent Technologies HP E1355A User Manual

OUTPut

Subsystem Syntax

[:STATe]

Parameters
Comments
Example
[:STATe]?
Example
Chapter 5
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
The OUTPut subsystem enables or disables the "Trig Out" port of the HP
E1300/E1301 Mainframe.
OUTPut
[:STATe] < state >
[:STATe]?
<state> enables/disables the "Trig Out" port on the rear
OUTPut[:STATe]
panel of the HP E1300/E1301 Mainframe.
the port and
OUTPut[:STATe] OFF | 0
Parameter Name
state
•
Downloaded FET Multiplexer Scans: The
does not work with downloaded FET multiplexer scan lists.
Downloaded scan lists are for use with the digital bus.
works with all other scanning modes.
•
Enabling "Trig Out" Port: When enabled, the "Trig Out" BNC is
pulsed each time a channel is closed during scanning.
•
Output Pulse: The pulse is a +5 V negative-going pulse.
•
"Trig Out" Port Reserved by Switchboxes: The "Trig Out"
resource is a system resource, and can only be reserved by one
switchbox instrument at a time.
•
Related Commands:
•
*RST Condition:
Enabling "Trig Out" Port
OUTP ON
queries the present state of the "Trig Out" port. The
OUTPut:[STATe]?
command returns 1 if the port is enabled, or 0 if disabled.
Query "Trig Out" Port State
OUTP ON
OUTP:STAT?
Strain Gage Multiplexer Command Reference
OUTPut[:STATe] ON | 1
disables the port.
Parameter Type
Boolean
,
[ROUTe:]SCAN TRIGger:SOURce
OUTPut[:STATe] OFF (port disabled)
Enables "Trig Out" port for pulse
output.
Enables "Trig Out" port for pulse
output.
Query port enable state.
enables
Range of Values
0 | 1 | ON | OFF
subsystem
OUTPut
OUTPut
79