Safety Switch; To Heat Properly - Fiat Capron T58 Manual

10.2.2
10.2.3
Hot air distribution
Adjusting the air outlet
nozzles
EN
Capron - 04-17 - CAP-0017-01

Safety switch

Fig. 78 Safety switch
In vehicles where the waste gas vent for the heater is positioned underneath
a hinged window, there is a danger that exhaust gases could get into the
vehicle if the hinged window is open. For this reason these vehicles have a
safety switch (Fig. 78,1) fitted on the hinged window.
If the hinged window is opened while the heater is in operation, automatic
shutoff stops the operation of the heater. This also applies if the hinged
window is opened in the "continuous ventilation" position.
If the heater was in operation when the hinged window was opened, it will
automatically restart when the hinged window is closed.

To heat properly

Fig. 79 Air outlet nozzle
Several air outlet nozzles (Fig. 79) are built into the vehicle. Pipes conduct the
warm air to the air outlet nozzles. Turn the air outlet nozzles in a suitable posi-
tion so the air can escape as required. To avoid draft close the air outlet noz-
zles on the dashboard and set the air distribution of the base vehicle to air
circulation.
Fully open: Full hot air stream
Half or partially open: Reduced hot air stream
When five air outlet nozzles are completely opened, less warm air escapes
through each nozzle. However, if only three air outlet nozzles are opened,
more warm air flows out of each nozzle.
10
Appliances
91