4.4
Extending:
Retracting:
EN
Capron - 04-17 - CAP-0017-01
Entrance step
Before commencing the journey and after short interruptions of the
journey, ensure that the entrance step is completely retracted.
Do not stand in the direct range of the entrance step while it is being
retracted or extended.
Do not step on the entrance step until it has extended completely. There
is a risk of injury.
Do not under any circumstances raise or lower persons or loads with the
entrance step.
Do not grease or lubricate the pivot bearing and joints of the entrance step
(see chapter 12).
The button to operate the entrance step is located on the inside of the
vehicle in the area of the conversion door.
If the entrance step has not been properly retracted and locked into place,
a warning tone is heard when the ignition is switched on.
In part, the vehicles are not equipped with an electrical entrance step but with
a low coupé entry that is comfortable to step on (model I).
Depending on the model, the vehicles have a one-or two-stage electrically
extendable entrance step.
Fig. 1
Operating switch entrance step
Before stepping on the entrance step, fully extend it.
Press the rocker switch (Fig. 1,1) down until the entrance step has
extended completely.
Press the rocker switch (Fig. 1,1) up until the entrance step has retracted
completely.
Before the journey
4
25