Panel (Lt 100); 12 V Main Switch - Fiat Capron T58 Manual

9.5
Mains connection
9.5.1
Switching on:
Switching off:
EN
Capron - 04-17 - CAP-0017-01

Panel (LT 100)

Fig. 69 Panel (LT 100)
1 12 V main switch and green LED
2 Mains connection symbol and yellow LED
3 Button to query the voltage of the living area battery
4 Button to query the fill level in the fresh water tank
5 Button to query the fill level in the waste water tank
6 LED array to display the tank fill level
7 LED array to display the battery voltage
The switches and push buttons of the panel are sensor touchpads. The
switching function is triggered by touching.
The yellow LED at the mains connection symbol
vehicle is connected to an external mains supply. In this case, the LED will
also be lit when the panel is switched off.

12 V main switch

The 12 V main switch (Fig. 69,1) switches the panel and the 12 V power
supply of the living area on and off.
Exception: Depending on the model, basic light (lighting in the entrance area),
and entrance step remain ready to operate.
Press switch " " (Fig. 69,1): The 12 V living area power supply is
switched on. The LED lights up green.
Press switch " " (Fig. 69,1) again: The 12 V living area power supply is
switched off. The LED goes out.
When leaving the vehicle, switch off the main 12 V power supply at the
panel. This prevents any unnecessary discharge of the living area battery.
Appliances, such as control units (e.g. solar charge regulator, defroster or
panel) or fitted appliances (e.g. step) continue to take power from the bat-
tery capacity, even if the 12 V power supply on the panel is switched off.
Therefore disconnect the living area battery from the 12 V power supply via
the switch on the transformer/rectifier if the vehicle will not be used for a
long period of time.
Electrical system
(Fig. 69,2) is lit when the
9
81