Extractor Hood (Recirculating); Refrigerator - Fiat Capron T58 Manual

10.3.3
Switching on:
Switching off:
10.4
EN
Capron - 04-17 - CAP-0017-01

Extractor hood (recirculating)

Maintain a distance of 65 cm between the extractor hood and open
flames.
Do not flambé under the extractor hood.
The appliance is connected to the 12 V power supply.
Always switch on the extractor hood when cooking. It is advisable to switch
on the extractor hood a few minutes before you start cooking. This causes
the air to start moving and odours can be dissipated more quickly.
After cooking, allow the air extraction to continue for a few minutes so that
any remaining odours can be neutralised.
The life of the bulbs can be extended by using the low lighting setting.
Further information can be obtained in the instruction manual for the
respective appliance.
Depending on the model, a recirculating extractor hood may be fitted above
the cooker. The fan draws in the cooking steam above the cooker. An acti-
vated carbon filter and a grease filter clean the air that has been drawn in and
it is then blown out again.
Fig. 90 Operation (extractor hood)
Set the switch (Fig. 90,1) for the fan motor to the " " position (low fan
speed) or the " " position (high fan speed).
Switch on the cooker lighting if necessary. Set the light switch (Fig. 90,2)
to the " " position (low lighting) or " " position (bright lighting).
Set the switch (Fig. 90,1) for the fan motor to the central position " ".
Set the light switch (Fig. 90,2) to the central position " ".

Refrigerator

During the journey, only operate the refrigerator via the 12 V power supply. At
high ambient temperatures the refrigerator is unable to reach its full cooling
power.
When leaving the vehicle, always mount the refrigerator ventilation grill.
Otherwise water can enter during rain.
Appliances
1 Switch for fan motor
2 Light switch
10
103