Table of Contents
Advertisement
Installing and Connecting the External Power Supply Shelf
Installation Procedures
2.
Partially install a screw
into the top hole of a
close (0.5-inch) pair on
both sides of the rack
Figure 2-2. Mounting screw positioning
3.
Figure 2-3. Installing bracket notches on screw
2-6
Partially install a screw into the top hole of a pair of holes that are 0.5
inches apart in each rack/cabinet upright as shown in the illustration
below. Ensure that the screws are at the same level in each upright.
Place the switch in the rack and lower it so the notches in the bottom of
the bracket slide onto the screws, then tighten these screws.
Advertisement
Table of Contents
Need help?
Do you have a question about the zl Series and is the answer not in the manual?
Questions and answers