Grizzly G0677 Owner's Manual page 38

Grease Fittings
Lubricant Frequency
NLGI #2 Grease Weekly
Wipe the fittings clean with a rag. Attach the
included flexible grease gun extension to a grease
gun. Add one or two pumps of grease to the
grease fittings (Figure 40 & 41) located on the
feed belt roller axles and the sanding belt roller
axles. They are identified with yellow labels.
Grease Fittings
Figure 40. Right/left grease fitting locations.
Grease
Figure 41. Feed belt roller grease fitting
locations.
-36-
Table Elevation Screws
Qty Lubricant
1-2 Pumps NLGI #2 Grease Monthly
from Grease
Gun Pull the dust covers down, and use a shop rag
and mineral spirits to wipe away the old lubricant
and built-up grime. Brush a thin coat of grease on
each table elevation screw (Figure 42). Be sure to
re-position the dust covers when finished.
Table Lifting Mechanism
Lubricant
NLGI #2 Grease Monthly
Open the right access panel and remove the
left lower side panel to access the table lifting
mechanism. Use a shop rag and mineral spirits to
remove the old lubricant and built-up grime. Brush
grease onto the chain and gears associated with
the table lifting mechanism (Figure 43). Be care-
ful to not get grease on the V-belts. This could
cause them to slip on the pulleys. If you do get
grease on them, replace them.
Frequency
Grease
Figure 42. Table elevation screw (shown with
dust cover).
Frequency
Figure 43. Table lifting mechanism lubrication
location.
G0677 24" Planer/Sander
Qty
Thin Coat
Qty
Thin Coat
Grease