T+A HV SERIES User Manual page 48

Mains cables and mains
filters
Changing the batteries:
Care of the unit:
Storing the unit
48
We recommend the use of the  'POWER THREE' ready-to-use mains lead in
conjunction with the 'POWER BAR' mains distribution panel, which is fitted
with a phase indicator as standard.
When you have completed the wiring of the system please set the volume
control to a very low level before switching the system on.
The screen on the PDT 3100 HV should now light up, and the unit should
respond to the controls.
If you encounter problems when setting up and using the amplifier for the first
time please remember that the cause is often simple, and equally simple to
eliminate. Please refer to the section of these instructions entitled 'Trouble
shooting'.
The mains power supply provides the energy which your sound system
equipment needs, but it also tends to carry interference from remote devices
such as radio and computer systems.
Our accessory range includes the specially shielded 'POWER THREE' mains
cable and the 'POWER BAR' mains filter distribution board which prevent
electro-magnetic interference from entering your Hi-Fi system. The
reproduction quality of our systems can often be further improved by using
these items.
dealer who will gladly give you comprehensive expert advice without obligation.
We would also be happy to send you our comprehensive information pack on
this subject.
Remove the screw marked in the figure below, to open the battery
compartment, and then withdraw the cover. Insert two new cells of the LR 03
(MICRO) type, taking care to maintain correct polarity as shown. Please note
that you must always replace all the cells.

Caution!
Batteries shout not be exposed to excessive heat like sunshine, fire or the
like.

Disposing of exhausted batteries:
Exhausted batteries must never be thrown into the household waste! They
should be returned to the battery vendor (specialist dealer) or your local
toxic waste collection point, so that they can be recycled or disposed in a
proper way. Most local authorities provide collection centres for such waste,
and some provide pick-up vehicles for old batteries.
Always disconnect the unit from the mains supply before cleaning it.
The surfaces of the case should be wiped clean with a soft, dry cloth only.
Never use solvent-based or abrasive cleaners!
Before switching the unit on again, check that there are no short-circuits at the
connections, and that all cables are plugged in correctly.
If the device has to be stored, place it in its original packaging and store it in
a dry, frost-free location. Storage temperature range 0...40 °C