Xerox Phaser 3635MFP Software Upgrade page 5

Note: A Configuration Report will be printed after the machine has rebooted
successfully. You can confirm the new software version from the printed report under
Printer Setup section under System Software Version listing.
Manual upgrade using Internet Services
This section provides instructions to upgrade machine software over the network
via Xerox CentreWare Internet Services (CWIS).
Information Checklist
Before starting the procedure, please ensure that the following items are available:
1. The upgrade file will have an [.hd] extension.
IMPORTANT: It is important to obtain the correct upgrade file for your particular model
of machine.
2. If you are performing the upgrade on a network connected machine, ensure that the
machine is online before continuing. TCP/IP and HTTP protocols must be enabled on
the machine so that the machine web browser can be accessed. Obtain the IP
address of the machine you want to upgrade.
Procedure
1. Open the web browser from your Workstation.
2. Enter the IP Address of the machine in the Address bar and select [Enter].
3. Click on the [Properties] tab.
4. Click on [Maintenance].
5. Click on [Upgrade Management]. If prompted, enter the User ID and Password of the
Administrator's account and click on [Login]. Note: Default User ID is admin, Default
Password is 1111
6. Verify Upgrades are Enabled. If not, then select the [Enabled] box. Click on the [OK]
button from the pop up window.
7. Click on [Firmware Upgrade].
8. In the [Firmware Upgrade] box select [Browse] to locate the software upgrade file on
your computer [.hd] that you obtained earlier.
9. Select the [.hd] file and click on the [Open] button.
10. Click on the [Install Software] button to proceed with the upgrade. You will be
prompted to confirm. Select [OK]. A pop up window will appear with the message
"Processing upgrade. It can take more than a minute." Click [OK] to close the window.
The file will be sent to the printer and will disable the printing functionality. The web
browser will become inactive and you will not be able to access the machine via this
method until the upgrade has completed and the machine has rebooted. The upgrade
should take no longer than 30 minutes. Once the machine has completed the upgrade
it will reboot automatically.
Note: A Configuration Report will be printed after the machine has rebooted
successfully. You can confirm the new software version from the printed report under
Printer Setup section under System Software Version listing.
5
GZ 12/01/08