Level 3 Programming; Machine Setup; Brew Oz - Bunn Axiom Series Technical Training Manual

SERVICE TOOLS ?
NO YES
FACTORY DEFAULTS
NO YES

Level 3 Programming

To access Level 3 programming press and hold the right hidden button, until the screen reads Cal. Temperature,
while on the Enter Password screen in Level 2 of programming.
CAL TEMPERATURE
NO SENSOR? YES
% Lime Adjust OFF
(-) DONE (+)
LP1 LP2 OZ 4.50
(-) DONE (+)
SPRAY OZ/M: 25.0
(-) DONE (+)
CALIBRATE FLOW ?
NO YES

Machine Setup

Brew Oz.

It is necessary to setup the desired Brew Oz., due to the different size containers available in the market.
To convert liters to ounces use this simple math equation.
Liters X 33.9 = ounces
For example if you were using a 3.0L airpot this is what your equation would look like.
3.0 X 33.9= 101.7 rounded up to 102 fluid US ounces.
Step 1: Enter programming Level 1, (BrewWIZARD
Step 2: Scroll to the Brew Oz. screen.
BREW OZ:
(-) DONE
Step 3: Use the (-) or (+) to enter Oz. the desired ounces for the container to be used.
10
AXIOM Training Manual
®
Allows the testing of individual components and the ability to check the membrane
switches for proper function.
Reset all of the previously entered brew settings, ad message, calibrations, etc.
This function allows the operator to "recalibrate" the CPU to the temperature thermistor.
This must be preformed when you replace a CPU or a thermistor.
This function allows for automatic adjustment of brew cycle times based on the output of
the sprayhead.
This function is used for calibration of the water volumes from the long level probe to the
short level probe.
This is used to tell the internal controller how fast the water is flowing.
This function provides a 60 second test mode to capture water from the sprayhead. This
measurement will then give you the numbers to enter into the "SPRAY OZ/M: xx" screen
above. Will not display when BrewLOGIC
®
64.0
(+)
is enabled.
®
).