Exterior Overview; Product Outlets And Removable Parts; User Interface (Operating) - Bunn Axiom Series Technical Training Manual

Machine Composition

Exterior Overview

Product Outlets and Removable Parts

• Faucet assembly
• Sprayhead
• Funnel
• Server

User Interface (Operating)

The user interface on the AXIOM
brane switch adhered to the front of the brewer. The
membrane is connected to the main control board by a
ribbon cable. This membrane allows the user to select
a brew cycle in addition to control the warmer plates
depending on model type.
The display is also located in the front of the machine it is mounted to the main board. By showing what the status of
the machine the display aids the operator and technicians.
BUNN
Enable Brew On/Off Switch: Pressing the "Enable Brew On/Off" switch (indicator on) supplies power to the brew
station warmer, enables the brew circuit, and energizes the tank refill circuit. Pressing the switch again (indicator off)
stops tank refilling and brewing and de-energizes the brew station warmer. Stopping a brew cycle after it has been
started will not stop the flow of water into the server until the brew funnel is empty.
Note: Hot water will be available at the faucet in a limited amount when the "Enable Brew On/Off" switch is in
the "Off" position because the tank will not refill.
Brew Switch: Momentarily pressing and releasing the switch starts a brew cycle when the "Enable Brew On/Off"
indicator is on.
Warmer Switches: Pressing any additional warmer switch so that the indicator is on, supplies power to the associ-
ated warmer. Note: APS and TC models have no warmers.
Faucet
Funnel
consists of a mem-
®
®
WARMER
Brew Switch
Enable Brew
On/Off Switch
™
REAR
FRONT
WARMERS
Warmer Switches
Bunn-O-Matic Corporation
Sprayhead
Server
15