Dubbing only desired scenes
– Digital program editing
Step 2: Setting the VCR to
operate with the A/V
connecting cable
To edit using the VCR, send the control signal by
infrared rays to the remote sensor on the VCR.
When you connect using the A/V connecting
cable supplied, follow steps (1) to (4) below, to
send the control signal correctly.
(1) Set the IR SETUP code
1 Set the POWER switch to PLAYER on
your camcorder.
2 Turn the power of the connected VCR on,
then set the input selector to LINE.
When you connect a video camera
recorder, set its power switch to VCR/
VTR.
3 Press MENU to display the menu.
4 Turn the SEL/PUSH EXEC dial to select
, then press the dial.
5 Turn the SEL/PUSH EXEC dial to select
VIDEO EDIT, then press the dial.
6 Turn the SEL/PUSH EXEC dial to select
EDIT SET, then press the dial.
7 Turn the SEL/PUSH EXEC dial to select
CONTROL, then press the dial.
8 Turn the SEL/PUSH EXEC dial to select
IR, then press the dial.
9 Turn the SEL/PUSH EXEC dial to select
IR SETUP, then press the dial.
0 Turn the SEL/PUSH EXEC dial to select
the IR SETUP code number of your VCR,
then press the dial.
Check the code in "About the IR SETUP
code" (p. 105).
112
–
(1)
1
2
3
4
5
6
7
8
9
0