Power Supply, Wiring And Switching - Reonix Automation SCADADroid R2 Technical User's Manual

Power Supply, Wiring and Switching

Power, input and output (I/O) wiring must be
in accordance with Class 1, Division 2 wiring
methods Article 501-4 (b) of the National
Electrical Code, NFPA 70 for installations in
Explosion hazard: Substitution of components may
impair suitability for Class 1, Division 2.
Risque d'explosion: La substitution de composants peut
nuire à la conformité de Classe 1 , Division 2.
Explosion hazard: When in a hazardous location turn off
power before replacing or wiring SCADADroid.
zone dangereuse couper l'alimentation électrique
avant de remplacer ou de câblage SCADADroid
Explosion hazard: Do not disconnect equipment unless
power has been switched off or the area is known to be
Risque d'explosion: Ne débranchez pas l'équipement
que l'alimentation est coupée ou que la zone est classé
Explosion hazard: Batteries must only be changed in an
Risque d'explosion: Les Batteries ne doivent etre
remplacees que dans un emplacement exempt de
Explosion hazard: Do not connect or disconnect when
Ne pas brancher ni debrancher sous tension.
the U.S., or as specified in Section 18-1.12 of
the Canadian Electrical Code for installations
within Canada and in accordance with the
authority having jurisdiction.
Risque d'explosion: Lorsque dans une
nonhazardous.
non dangereux.
area free of ignitible concentrations.
concentrations inflammables.
energized
Setting Up The R2
11