Table of Contents
Advertisement
Description
Load segments
- Auto shutdown
delay
In/Out Settings
Overload
prealarm
Cold start
Forced reboot
Auto restart
ON/OFF Settings
Energy saving
Sleep mode
Remote command
RPO delay
Low battery
warning
Battery Settings
Restart battery
level
Available Settings
[Disable] [0s] [1 s] [2 s]...[65354 s]
During a power outage,
authorizes UPS to turn off power to
equipment connected to Group 1
and/or Group 2 outlets.
This feature allows the shedding of
non-critical loads in order to conserve
battery power for critical loads
connected to the Primary group.
[10 %] [15 %] [20 %] ... [100 %] [105 %]
Sets critical percentage of load where
alarm overload alarm occurs.
[Disable] [Enable]
Enables the product to be started on
battery power.
First cold start is always disabled.
[Disable] [Enable]
If mains recover during a shutdown
sequence:
- if enabled, shutdown sequence will
complete. Wait 10 seconds prior to
restart.
- if disabled, shutdown sequence will
not complete, and restart will occur
immediately.
[Disable] [Enable]
Enables the product to restart
automatically when mains recovers
after a complete battery discharge.
[Disable] [Enable]
If enabled, UPS will shutdown after
5 min of back-up time, if no load is
detected on the output.
[Disable] [Enable]
If disabled, LCD and communication
will turn OFF immediately after UPS
is OFF.
If enabled, LCD and communication
stays ON 1h30 min after UPS is OFF.
[Disable] [Enable]
If enabled, shutdown or restart
commands from software are
authorized.
[0 s] [1s ] [2 s]...[180 s]
Delays remote power off command
[1 %] [2 %] ... [100 %]
The alarm triggers when the set
percentage of battery capacity is
reached during a back-up time.
[1 %] [2 %] ... [100 %]
If set, automatic restart will occur
only when percentage of battery
charge is reached.
2. Presentation
Default Settings
Group 1: Disable
Group 2: Disable
[105 %]
Enable
Enable
Enable
Disable
Disable
Enable
[0 s]
20 %
0 %
Page 11
Advertisement
Table of Contents
