Replacing Lifter/Lifter Controls - Invacare CometALPINE+ Service Manual

1. Remove seat.
2. Remove shroud.
3.
Disconnect battery cable A.
4.
Remove top shroud A from steering column B.
5.
Remove screws A below operating console.
6. Remove operating console and fold upwards.
7. Remove screws C on drive lever B and remove drive
lever.
8.
LCD
Fig. 5-3
Disconnect potentiometer plug A from operating
console.
1603798-D
9.
10. Replace potentiometer.
11.
12.
13. Install parts in reverse order.
14. Test all functions (trial run).

5.5.4 Replacing lifter/lifter controls

LED
Fig. 5-4
1. Secure mobility device against rolling away.
2. Remove seat.
Remove screws A on potentiometer.
LCD
Fig. 5-5
Reconnect potentiometer plug A with operating
console.
Connect potentiometer A and drive lever mounting B:
• Tighten screw C.
CAUTION!
Risk of accident
Accidental rolling can lead to accidents.
– Secure mobility device against rolling away.
When disassembling, note position of small parts
such as screws and washers. Put small parts down
so that they can be reassembled in right sequence.
• 14 mm wrench
• Phillips screwdriver
Service
LED
Fig. 5-6
17