Mounting; Mounting Instructions - Vega VEGAMAG 81 Supplementary Instructions Manual

2 Mounting

Seals
Close openings
Vessel pressure test
6
2 Mounting
2.1

Mounting instructions

The seals for the vessel connections (B) and the vent connection (E)
must be provided by the customer.
The gaskets for the chamber closing on top (A), the chamber closing
at the bottom (C) and the drain connection (F) are enclosed to the
shipment. You can find the seal materials in chapter "Technical data".
Before use, check if the seal material is resistant against the medium,
the process pressure and the process temperature.
Close all drain connections before the setup of VEGAMAG 81. Check
if all connections of VEGAMAG 81 are tight.
A mounted bypass pipe must also withstand any pressure test that
might be carried out on the vessel. Keep the pressure specification on
the type label in mind.
Caution:
Remove the float from the pipe before you start the pressure test.
VEGAMAG 81 •