Grizzly G0852 Owner's Manual page 18

5. Attach (2) lower rear legs to base stand and
finger-tighten each one using (2)
hex bolts and (2)
Figure 13).
Note: Each lower rear leg has (2) extra
threaded ⁄ "-18 bolt holes on inner edges.
5
16
(2) ⁄ "-18
5
16
Bolt Holes
Lower
Rear
Legs
Figure 13. Lower rear legs installed.
6. Attach each leg brace to lower legs and
finger-tighten with (4)
and (4) ⁄ " fender washers (see Figure 14).
5
16
Leg
Braces
x 4
Figure 14. Leg braces installed.
-16-
⁄ "-18 x
5
16
⁄ " fender washers (see
5
16
x 2
⁄ "-18 x ⁄ " hex bolts
5 3
16 4
7. Attach (2) upper legs to each brace (see
⁄ " Figure 15), then finger-tighten each upper
3
4
leg with (2)
fender washers.
Figure 15. Upper legs installed.
8. Place square gasket on intake barrel (see
Figure 16, inset), then attach upper cover to
intake barrel using (12)
and (12)
Tighten in star pattern.
Square
Gasket
Intake
Barrel
Upper
Cover
x 12
Figure 16. Upper cover attached to intake barrel.
⁄ "-18 x ⁄ " hex bolts and (2)
5 3
16 4
⁄ "-18 x
5
16
⁄ " fender washers (see Figure 16).
5
16
Model G0852 (Mfd. Since 12/18)
⁄ "
5
16
Upper
Legs
x 2
Leg
Brace
⁄ " hex bolts
3
4
Intake
Barrel