Requirements; Software; Hardware; Atmel Qt600 System Description - Atmel AVR8015 Application Note

3 Requirements

3.1 Software

3.2 Hardware

NOTE

3.3 Atmel QT600 system description

32185A-AVR-01/12
Make sure you install the latest versions of:
• Atmel QTouch Studio 4.3.x (www.atmel.com/avrqtouchstudio)
• Atmel QTouch Library 4.4 (www.atmel.com/qtouchlib)
QTouch Library User Guide
o
QTouch Library Selection Guide
o
• Atmel AVR Studio 5 – Latest (www.atmel.com/avrstudio)
In this hands-on training we are going to use:
• Atmel QT600 Interface Board
• Atmel QT600 – AT32UC3L-QM64
• Atmel QT600 – QMatrix 8x8 Touch Sensor board
• Debugger – Atmel AVR JTAGICE mkII with squid cable
AVR JTAGICE mkII with hardware revision 0 does NOT have aWire capabilities.
Hence AVR JTAGICE mkII other than hardware revision 0 should only be used. Any
of the following debuggers maybe also used Atmel JTAGICE 3, Atmel STK600 and
Atmel AVR ONE!.
The QT600 system is based on three boards connected together.
• QT600 Interface Board
• QT600 MCU Board
• Touch Sensor Board
Figure 3-1. QT600 system.
The MCU board and touch sensor boards together comprise the user touch system.
The QT600 interface board is used to stream live touch data from the Atmel AVR
Atmel AVR8015
3