Connecting The Hardware - Atmel AVR8015 Application Note

4.1.2 Connecting the hardware

Atmel AVR8015
8
Figure 4-4. Writing output file into the target device.
1. Connect the USB cable to the Atmel QT600 interface board.
2. Make sure the VTG header is mounted on the QT600 interface board.
3. Connect the TOUCH DATA header of the QT600 interface board and Atmel
QT600-AT32UC3L-QM64 board.
4. Connect the JTAGICE mkII and the QT600-AT32UC3L-QM64 board through the
aWire interface as described in Section 4.1.1.
Figure 4-5. Squid connection.
5. Make sure that the QT600 interface board is in the default data streaming mode.
6. Ensure the target voltage is set as per the device datasheet. Minimum voltage is
1.8V.
7. Program the application code (
instructions on how to do this, see the help section in
8. Disconnect the USB plug from the Atmel QT600 interface board.
uc3l_gnu_qm_qt600.hex
Atmel AVR Studio
). For detailed
5.
32185A-AVR-01/12