Troubleshooting; Removing From Service - CDI Traxall X200 User Manual

TROUBLESHOOTING

Connec on and Communica on
CDI transmi ers, when supplied with fresh ba eries of the proper type
and size, should automa cally connect to the FieldLink interface on your
PC and display the transmi er serial number.
To conserve ba ery power during a pig run, the FieldLink radio is
deac vated a er fi ve minutes if no connec on has been established.
To reac vate FieldLink, the device must be power-cycled by removing and
reinstalling ba eries.
If your transmi er fails to establish communica on a er following all
ba ery installa on and Fieldlink confi gura on procedures, it will be
necessary to contact CDI at 1-800-580-4234 or 918-258-6068 for product
support.
REMOVING TRANSMITTER FROM SERVICE
Always remove ba eries before placing the unit into storage.
Failure to do so may result in damage and may void warranty.
Always ensure immediate environment is free of explosive gases, liquids,
or other substances.
Always use cau on when opening any CDI transmi er that has
been in a pressurized environment.
It is possible for pressurized liquid or gas to leak into a transmi er
and remain there even a er the transmi er has been removed from
the pipeline. For this reason, always point the transmi er away from
yourself or others when opening a cover or end cap.
As possible for liquids to be present within cap threads, point
transmi er downward to drain liquid out of and away from transmi er
components or ba eries.
TRAXALL X200 Series Mul frequency Transmi er User Guide
WARNING:
WARNING
Page 26 of 32