Prepare Transmitter: Power - CDI Traxall X200 User Manual

PREPARE TRANSMITTER: POWER

End Caps
All CDI transmi ers have a knurled threaded cap on each end. To prepare
the X200 for opera on you will need to momentarily remove these caps
to access the ba eries and confi gura on antenna. Observe nomenclature
on transmi er case to determine correct cap, ba ery quan ty, and ba ery
polarity. Ba ery and antenna end caps are not interchangeable (antenna
caps are le -hand threaded) but removal and replacement procedures are
similar.
The X200 is available in 2AA and 3AA versions. They diff er in performance,
case dimensions (length) and number of ba eries required, but
confi gura on and ba ery installa on procedures are essen ally the same
for all versions. rsions.
ANTENNA CAP
Always observe these precau ons before removing any transmi er
end cap:
Ensure immediate environment is free of explosive gases, liquids, or
other substances.
Use cau on when opening any CDI transmi er that has been in
a pressurized environment.
It is possible for pressurized liquid or gas to leak into a transmi er
and remain there even a er the transmi er has been removed from
the pipeline. For this reason, always point the transmi er away from
yourself or others when opening a cover or end cap.
As it is possible for liquids to be present within cap threads, point
transmi er downward to drain liquid out of and away from transmi er
components or ba eries.
TRAXALL X200 Series Mul frequency Transmi er User Guide
Page 7 of 32
BATTERY CAP