Table of Contents
Advertisement
N. POWER RECLINE OPERATION
(Standard operating instructions)
!
WARNING
Make sure the power wheelchair is on a
level surface
before proceeding with recline mode.
FOUR-WAY TOGGLE
Increasing recline angle
A
Pull the four-way toggle switch
back until the desired recline
angle is achieved and release.
Decreasing recline angle
B
To reverse the recline angle
direction, release the four-way
toggle switch to the neutral
position for at least 1 second and
pull the four-way toggle switch
back until the desired recline
angle is achieved and release.
PUSH BUTTON SWITCHES
Increasing recline angle
Push the 2
nd
button until the desired
recline angle is achieved and release.
Decreasing recline angle
To reverse the recline angle direction,
release the 2
button to the neutral
nd
position for at least 1 second and
push the same button until the desired
recline angle is achieved
and release.
2
push button
nd
32
A
B
LEVEL SURFACE
TIP LIMIT SWITCH
When equipped with a tilt and power or manual recline
combination, your power wheelchair will include a tip
switch located inside the shroud, on the right side of the
power wheelchair. The purpose of the tip switch is to
control the combination of the total tilt/recline angle.
This tip switch can be manually turned to change the total
tilt/recline angle to a desired or comfortable level for the
user. The total tilt and recline angle should never exceed
the horizontal plane (180°). Technicians must watch for
A
a possible tilt actuator behind the seat that would reduce
the total tilt/recline limit. The total tilt and recline angle
should be limited prior to contact between the shroud and
the tilt actuator.
B
Tip limit switch
O. POWER ELEVATING FRONT RIGGINGS OPERATION
(Standard operating instructions)
!
WARNING
Make sure the power wheelchair is on a
level surface.
INCREASING & DECREASING
THE LEFT LEGREST ANGLE
Four-way toggle
Move the four-way toggle switch
towards the left side of the wheelchair
until the desired legrest angle is
achieved. To reverse the legrest
angle direction, release the four-way
toggle switch to the neutral position
for at least 1 second and move the
four-way toggle switch towards the
left side of the wheelchair until the
desired legrest angle is achieved.
Push button switches
Push the 3
rd
button until the desired
legrest angle is achieved and release.
To reverse the legrest angle direction,
3
push
rd
button switch
release the 3
button to the neutral
rd
position for at least 1 second and
push the same button until the desired
legrest angle is achieved
and release.
!
WARNING
Make sure the power wheelchair is on a
level surface.
INCREASING & DECREASING
THE RIGHT LEGREST ANGLE
Four-way toggle
Move the four-way toggle switch
towards the right side of the
wheelchair until the desired legrest
angle is achieved. To reverse the
legrest angle direction, release
the four-way toggle switch to the
neutral position for at least 1 second
and move the four-way toggle
switch towards the right side of the
wheelchair until the desired legrest
angle is achieved.
Push button switches
Push the 4
th
button (closest to the
4
th
push
wire) until the desired legrest angle is
button switch
achieved and release. To reverse the
legrest angle direction, release the
4
button to the neutral position for
th
at least 1 second and push the same
button until the desired legrest angle
is achieved and release.
33
Advertisement
Table of Contents
