Instructions For Operation - Sunrise Medical Quickie Nitrum Quick Start Manual

Instructions for Operation

Switching the lights on: by pushing the button A on top of the
control-Box (Fig.3), you can cycle through operating-modes of
the LEDs:
1. Full power mode
2. Low-power mode
3. Flash-mode
4. Off
The charging-status of the battery is indicated by the backlit
button A :
• red: charging-status <50%
• red (when battery is connected to the charger): battery is
charging
• green (when battery is connected to the charger): battery
fully charged
Remove the control-box from the calf-strap for charging:
detach cables on the sides by gently pulling the pins out of the
connectors (C). Now pull the control-box upwards to remove it
from the calf-strap.
Charge the battery: connect the USB-cable to the connector
(B) on the front-side of the control-Box. Use a standard USB-
charger or your Computer´s USB-port to charge the battery.
Green light will indicate a fully charged battery.
Battery Specification:
Battery-type
Nominal capacity
Nominal voltage
Charging time
A
B
LED Light retrofit Art.nr. 66009910
Lithium-Ion
2600mAh
3.6V
3 hours
Fig. 3
C
Rev.A
WARNING
• Before you use the LED light for the first time, please make
sure to fully charge the battery
• The Control-Box contains a Lithium-Ion battery, which is a
hazardous product.
• Electrical and electronic equipment need to be disposed of
separately to general household waste at specific state
provided locations. The correct disposal and separate
collection of used appliances serves to prevent potential
damage to health and the environment. It is a requirement
for the re-utilisation and recycling of used electrical and
electronic equipment.
• Detailed information on the disposal of your used equipment
can be obtained from your local authority, your waste
disposal service, the specialist dealer from which you
purchased the product, or your sales contact.
3