Power Tilt Operation; Power Seat Elevator Operation - Sunrise Medical Quickie Xperience 2 Owner's Manual

J. POWER TILT OPERATION
(Standard operating instructions)
!
WARNING
Make sure the power wheelchair is on a level surface before
proceeding with tilt mode.
LEVEL SURFACE
1. SINGLE ACTUATOR TOGGLE SWITCH
Increasing tilt angle
Pull the toggle switch (located next to the wheelchair
joystick) backward until the desired tilt angle is achieved,
then release.
Decreasing tilt angle
Release the toggle switch to the neutral position for at least
1 second and push the toggle switch (located next to the
wheelchair joystick) forward until the desired tilt angle is
achieved, then release.
28
2. DRIVE LOCK-OUT
Drive lock-out is a safety feature designed to prevent the
power wheelchair from being driven while in a tilt angle
over 15° relative to the horizontal position.
DANGER
Never operate the power
wheelchair while in tilt
with an angle over 15°
relative to the horizontal
position. If the drive
lock-out does not stop
the wheelchair from
operating when in a tilt
angle over 15°, have
it or the power tilt
system serviced by an
authorized supplier or
qualified technician.
K. POWER SEAT ELEVATOR OPERATION
(Standard operating instructions)
!
WARNING
Make sure the power wheelchair is on a level surface before
proceeding with elevate mode and drive in reduced speed
while elevated.
LEVEL SURFACE
1. SINGLE ACTUATOR TOGGLE SWITCH
Increasing seat height
Pull the toggle switch (located next to the wheelchair
joystick) backward until the desired height is achieved,
then release.
Decreasing seat height
Release the toggle switch to the neutral position for at least
1 second and push the toggle switch (located next to the
wheelchair joystick) forward until the desired height is
achieved, then release.
2. DRIVING IN REDUCED SPEED
Reduced drive speed is a feature designed to allow the user
to drive the wheelchair at a reduced speed while lifted
up to 11" (280 mm). When elevated, the drive speed is
then reduced to 25% of its original setting. Full drive
speed is achieved when the seat elavator is down to its
lowest position.
DANGER
Never operate the seat elevator when the power
wheelchair is on any slope. In reduced speed, the
wheelchair must be driven on a level surface. If the
reduced speed does not slow the wheelchair's drive speed
to 25% of its original settings, have it or the power seat
elevate system serviced by an authorized supplier or
qualified technician.
29