Removing And Replacing An Nvme Drive - HP HPE ProLiant DL180 Gen10 Maintenance And Service Manual

To replace the component, reverse the removal procedure.

Removing and replacing an NVMe drive

An NVMe SSD is a PCIe BUS device. Devices attached to a PCIe bus cannot be removed without
allowing the device and the bus to complete and cease signal/traffic flow.
Procedure
1. Back up all server data on the drive.
2. Determine the status of the drive from the drive LED definitions.
3. Remove the drive.
a. Push the Power button.
The Do Not Remove button illuminates and flashes.
b. Wait until the flashing stops and the Do Not Remove button is no longer illuminated.
c. Push the Do Not Remove button and then remove the drive.
To replace the component, reverse the removal procedure.
42 Removal and replacement procedures