In-Line Chlorine Feeders; Water Flow Rates - Aquacal TropiCool TC500 Installation Manual

1.4.d In-Line Chlorine Feeders
Place in-line chlorinators downstream from the chiller and as low in elevation as possible.
If an erosion type feeder is used, it is recommended that a Hartford Loop be installed to protect internal chiller
l
components.
A Hartford Loop is not necessary with a Salt Chlorine Generator.
l
1.4.e Water Flow Rates
Maintain water flow rates as indicated. Please note, these specifications relate to the chiller only. Code-
specified whole system turnover rates must be satisfied.
NOTICE
Water flow exceeding maximum flow rates will negatively affect the total pool filtration performance and may
l
damage the chiller. This will not be covered under equipment warranty.
MODEL
TC500
TC1000
TC1500
PLEASE NOTE -
If minimum flow rates are not met, chiller performance is reduced and performance will
suffer. Internal safety devices may deactivate the chiller with the following errors:
HP and HP5
l
or (if equipped) error codes of LP and LP5
l
Operate water filtration devices per manufacturer's specifications. Dirty filters can cause a reduction of water flow
l
to the chiller. An increase of 7-10 psi higher than the clean filter pressure typically reduces flow rates. This
requires the filter to be cleaned or back-washed.
Keep baskets free of debris. A large quantity of debris in the pump and skimmer baskets can reduce water flow.
l
Check for improper valve settings. A partially closed valve after the filter, or a full-open bypass around the
l
chiller, will cause insufficient water flow through the chiller.
Page - 9
Chiller with Hartford Loop
Failure to heed the following may result in damage to equipment.
HEAT EXCHANGER TYPE
Titanium Tube-in-Tube
Titanium ThermoLink
Titanium ThermoLink
FLOW RATES
MINIMUM MAXIMUM
20 GPM
®
30 GPM
®
30 GPM
45 GPM
70 GPM
70 GPM