Measurements; Selection Of General Measurement Parameters - Sonel MZC-305 Operation Manual

Due to continuous development of the meter software, the display view for some
functions may be a bit different from the view shown in this manual.
During measurements, the earthed parts and parts accessible in the electrical
installation being tested must not be touched.
During a measurement, switching of the range switch is forbidden because it
may damage the meter and pose a threat to the user.
2.1

Selection of general measurement parameters

6
2

Measurements

The SEL button is used to go to the next
parameter and to confirm the changes in the
currently displayed parameter.
SEL
Use the
parameter value. The value or symbol to be
changed is flashing.
The
the
Set the parameters according to the following algorithm:
OPERATING MANUAL MZC-305 version 1.08
Note:
WARNING:
WARNING:
Keeping the SETUP button
depressed, turn on the meter and wait
for the parameter selection screen.
and buttons to change the
symbol indicates an active parameter,
symbol indicates an inactive one.