Advertisement
ADJUSTMENT
Adjusting the Pattern Width
1
Setting the Width
adjustment shutters
Ajusting the Width Angle
Left or Right : between 0 to 7
(3.5 per click)
to Right
t
o Left
Setting the pattern for exact door opening may give a slow response to side approaching traffic.
Note
Adjusting the Pattern Depth
2
With any convination the
Dipswitch7 & 8, only one
row is active.
Ajusting the Depth Angle
between -4 to 4
(1 per click).
Shallow
Depth
Note
Set the pattern for actual traffic. It may cause slow activation for the traffic from the front, when the Row is eliminated.
Setting of Sensitivity Switch and Dipswitches
3
Sensivity Switch
Setting the Sensitivity
Normally set to"M".
"H" increases the sensitivity and "L" lowers the sensitivity.
Setting the Presence timer
All areas provide
the presence detection.
(1) Select the presence detection time.
(2) Turn the power off and on again. Otherwise it may
leave door open for the duration of the presence
time set.
(3) After making sure that the door closes, wait for 10
seconds before entering the detection area to set
the Presence timer.
Pattern when Standard
: Erasable
Area
Pattern when Standard
Dipswitches
Pattern when changed 7
to Left
: Erasable
Area
Pattern when changed -4
to Shallow (inside).
Setting the Frequency Function
( interference Prevention )
Four different frequencies can
be set by adjusting the
Dipswith3 and 4.
Note
When two or more sensors are installed close to each
other, it is possible that they interfere. When that happens
, change the Frequency.
Setting the Immunity
Set the Dipswitch5 and 6 to
Immunity , if the sensor is used
in a region with snow or
a lot of insects.
Pattern when changed 7
to Right
: Erasable
Area
Pattern when changed 4
to Deep (outside).
Advertisement
