Table of Contents
Advertisement
BioMonitor SmartLead
It is recommended that you redetect sensors in the
hardware configuration every time the SmartLeads are
removed from the Ultium sensor (redetection is necessary
to revert to the use of the sensor's EMG functionality).
This will prevent configuration errors leading to the
inability to collect a measurement. If an error message
pops up when starting a measure, and you are using
SmartLeads, this is a good first troubleshooting step (1.
Redetect sensors in hardware set-up; 2. Double check the
configuration).
*
See Find My Sensor section below
P852 Rev B (April 2019)
Step 3
Once back in the Home
screen, choose to create a
new or edit an existing
configuration.
Step 4
In the measurement setup
screen, insert the Ultium
system into the Devices in
your configuration box.
9
Advertisement
Table of Contents
