Vehicle Lights; Replacing A Turn Signal Light Bulb; Supporting The Motorcycle - Yamaha MT-15 Owner's Manual

Vehicle lights

This model is equipped with LED lights
for headlights, auxiliary lights and
brake/tail light. If a light does not come
on, check the fuse and then have a
Yamaha dealer check the vehicle.
1
2
1. Auxiliary light
2. Headlight
NOTICE
Do not affix any type of tinted film or
stickers to the headlight lens.
Periodic maintenance and adjustment
EAUN2261
Replacing a turn signal light
bulb
1. Remove the turn signal light lens
by removing the screw.
1. Screw
2. Remove the burnt-out bulb by
pushing it in and turning it coun-
terclockwise.
ECA16581
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
screw. NOTICE: Do not over-
tighten the screw, otherwise the
lens may break.
EAU24205

Supporting the motorcycle

Since this model is not equipped with a
centerstand, follow these precautions
when removing the front and rear
wheel or performing other mainte-
nance requiring the motorcycle to
stand upright. Check that the motorcy-
cle is in a stable and level position be-
fore starting any maintenance. A
strong wooden box can be placed un-
der the engine for added stability.
1
To service the front wheel
1. Stabilize the rear of the motorcy-
2. Raise the front wheel off the
To service the rear wheel
Raise the rear wheel off the ground by
[ECA11192]
using a motorcycle stand or, if a motor-
cycle stand is not available, by placing
7-32
cle by using a motorcycle stand
or, if an additional motorcycle
stand is not available, by placing a
jack under the frame in front of the
rear wheel.
ground by using a motorcycle
stand.
EAU24351
7