Yamaha MT-15 Owner's Manual page 69

Drive chain slack:
30.0–40.0 mm (1.18–1.57 in)
4. If the drive chain slack is incorrect,
adjust it as follows. NOTICE: Im-
proper drive chain slack will
overload the engine as well as
other vital parts of the motorcy-
cle and can lead to chain slip-
page or breakage. To prevent
this from occurring, keep the
drive chain slack within the
specified limits.
[ECA10572]
To adjust the drive chain slack
Consult a Yamaha dealer before ad-
justing the drive chain slack.
1. Loosen the axle nut and the lock-
nut on each side of the swingarm.
Periodic maintenance and adjustment
1
1. Axle nut
2. Locknut
2. To tighten the drive chain, turn the
drive chain slack adjusting bolt on
each side of the swingarm in di-
EAU3431A
rection (a). To loosen the drive
chain, turn the adjusting bolt on
each side of the swingarm in di-
rection (b), and then push the rear
wheel forward. NOTICE: Improp-
er drive chain slack will over-
load the engine as well as other
vital parts of the motorcycle and
can lead to chain slippage or
breakage. To prevent this from
occurring, keep the drive chain
slack within the specified limits.
[ECA10572]
TIP
Using the alignment marks on each
side of the swingarm, make sure that
both drive chain pullers are in the same
position for proper wheel alignment.
2
1. Locknut
2. Drive chain slack adjusting bolt
3. Alignment marks
3. Tighten the axle nut, then the lock-
7-24
1 2
(b)
(a)
3
nuts to their specified torques.
Tightening torques:
Axle nut:
59 N·m (5.9 kgf·m, 44 lb·ft)
Locknut:
16 N·m (1.6 kgf·m, 12 lb·ft)
7