Handlebar Switches - Yamaha MT-15 Owner's Manual

Instrument and control functions
8. After the sixth character is set, all
characters will flash twice and the
setting mode will automatically
end.
Screen brightness control mode
To adjust the screen brightness
4
1. Turn the main switch off.
2. Push and hold the "SELECT" but-
ton.
3. Turn the main switch on and then
release the "SELECT" button after
five seconds.
4. Push the "RESET" button to select
the desired brightness level.

Handlebar switches

Left
1
2
1. Pass switch "PASS"
2. Dimmer switch " / "
3. Horn switch " "
4. Turn signal switch " / "
Right
1
1. Start/Engine stop switch "
4-11
EAU1234M
Dimmer/Pass switch "
Set this switch to "
beam and to "
To flash the high beam, push the
switch down towards "PASS" while the
headlights are on low beam.
Turn signal switch "
To signal a right-hand turn, push this
switch to "
3 turn, push this switch to "
4
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
Horn switch "
Press this switch to sound the horn.
Engine stop switch "
Set this switch to "
starting the engine. Set this switch
to " " (stop) to stop the engine in case
of an emergency, such as in the event
of an overturn or if the throttle is stuck.
/ / "
EAU54202
/ /PASS"
" for the high
" for the low beam.
EAU12461
/ "
". To signal a left-hand
". When
EAU12501
"
EAU12663
/ "
" (run) before