Air Filter Element And Check Hose - Yamaha MT-15 Owner's Manual

1
1. Coolant reservoir cap
6. Add coolant to the maximum level
mark, and then install the coolant
reservoir cap. WARNING! Re-
move only the coolant reservoir
cap. Never attempt to remove
the radiator cap when the en-
gine is hot.
[EWA15162]
coolant is not available, use dis-
tilled water or soft tap water in-
stead. Do not use hard water or
salt water since it is harmful to
the engine. If water has been
used instead of coolant, replace
it with coolant as soon as possi-
ble, otherwise the cooling sys-
tem will not be
against frost and corrosion. If
water has been added to the
coolant, have a Yamaha dealer
check the antifreeze content of
the coolant as soon as possible,
otherwise the effectiveness of
the coolant will be reduced.
[ECA10473]
Coolant reservoir capacity (up to
the maximum level mark):
0.15 L (0.16 US qt, 0.13 Imp.qt)
7. Install the cowling.
Changing the coolant
The coolant must be changed at the in-
tervals specified in the periodic main-
tenance and lubrication chart. Have a
NOTICE: If
Yamaha dealer change the coolant.
WARNING! Never attempt to remove
the radiator cap when the engine is
hot.
[EWA10382]
protected
Periodic maintenance and adjustment
EAU33032
7-14
Air filter element and check
hose
The air filter element should be cleaned
or replaced by a Yamaha dealer at the
intervals specified in the periodic main-
tenance chart. Have the air filter ele-
ment serviced more frequently if you
often ride in wet or dusty areas. In ad-
dition, the air filter check hose should
be regularly checked and cleaned if
necessary.
To clean the air filter check hose
1. Check the hose for accumulated
dirt or water.
1. Air filter check hose
EAUU2170
7
1