DirecTV Advanced Installation Meter 2 Operation Manual page 79

6. Connect the AIM ODU F connector at the
location in the distribution network where you
want to test.
To test between the ODU and the multiswitch,
disconnect the cable connecting the ODU to
the multiswitch and connect it to the AIM's ODU
F connector.
7. Press NEXT to go to the SAT TUNE screen.
8. If the installation includes two ODUs, highlight
the ODU to test and press SELECT to
continue.
9. Highlight the orbital slot to test or use the
keypad to enter the slot number, and press
SELECT to continue.
10. If you want to set the SWiM (or DSWiM)
channel for the test, do the following:
• Press OPTIONS.
On the SAT TUNE OPTIONS screen,
•
press SELECT to select Set SWiM Ch.
(Connect SWiM).
• Highlight the desired channel and press
SELECT.
11. Highlight the transponder to test. Then press
SELECT and wait briefly for the results of the
test.
You also can use the keypad to enter the
transponder number. Use PAGE UP or PAGE
DN to scroll quickly through the transponders.
AIM 2 Operation Manual
Page 79