3. Troubleshooting Image Quality Problems
Solution:
Before you perform the solution procedure, make sure that the environmental conditions where you are
using the machine meet those recommended for use. For details on the environmental conditions for use,
see "Where to Put Your Machine", Maintenance and Management.
The solution depends on the interval.
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Registering a Custom Paper", Preparation.
Approximately 12-18 mm (0.5-0.7 inches)
Approximately 60 mm (2.4 inches)
Approximately 95 mm (3.7 inches)
Approximately 314 mm (12.4 inches)
• For details about replacing the photoconductor unit, see Replacement Guide.
Entire Image Faint
The entire image is fainter than normal.
52
Interval
CEZ585
Solution
Contact your service representative.
Select [Machine: Paper Feed / Output] in [Advanced
Settings] for the custom paper in use and adjust the
set value of [Transfer Timing Roller] in 1351: [Motor
Speed] according to the paper type and thickness.
If the problem persists, contact your service
representative.
Contact your service representative.
Replace the photoconductor unit. If the problem
persists, contact your service representative.