Finisher Sr5110/Booklet Finisher Sr5120; Delivered Sheets Are Not Stacked Properly - Ricoh Pro 8300S Operating Instructions Manual

Finisher SR5110/Booklet Finisher SR5120

Delivered Sheets Are Not Stacked Properly

Solution:
Depending on the cause of the problem, do one of the following:
Coated paper is being used.
If coated paper is being used, attach the Z-fold support tray for multi-folding unit.
For details about attaching the Z-fold support tray for multi-folding unit, see "Preparation" supplied with
the machine.
There is airflow in the room.
Minimize the airflow. For instance, turn the air conditioner off.
Printed sheets are curled.
<If the decurler unit is used>
1. In the [Machine: Paper Feed / Output] group on the [Adjustment Settings for Operators]
menu, select 0310: [Correct Output Paper Curl] and adjust the degree of decurling.
To correct curls facing up, specify "U Curl Correction Level".
To correct curls facing down, specify "П Curl Correction Level".
Select "Large" or "Small" depending on the degree of decurling required.
<If the decurler unit is not used>
1. Load the sheets the other way up.
There are too many stacked sheets.
Reduce the number of the stacked sheets. To do this, suspend printing and remove the stacked sheets,
and then resume printing.
To suspend printing, press the [Suspend / Resume] key on the finisher.
To resume printing, press the [Suspend / Resume] key on the finisher.
Finisher SR5110/Booklet Finisher SR5120
141