Ricoh Pro 8300S Operating Instructions Manual page 165

Solution:
The solution depends on whether letter folding is applied to multiple sheets or a single sheet.
<When letter folding is applied to multiple sheets>
1. Load the paper the other side up.
2. Print the image. Is the problem resolved?
Yes Finished!
No Go to the next step.
3. In the [Finishing: Fold] group on the [Adjustment Settings for Operators] menu, set
0810: [Letter Fold-in Position 1: Multi-sheet Fold] to "0.0 mm".
4. In [General Features] in [System Settings], set [Letter Fold-in Position] for multiple
sheets to "7 mm".
5. Print the image. Is the problem resolved?
Yes Finished!
No Contact your service representative.
<When letter folding is applied to a single sheet>
• This procedure is applied especially to coated paper.
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For
details about registering custom papers, see "Registering a Custom Paper", Preparation.
1. In [General Features] in [System Settings], set [Letter Fold-in Position] for a single
sheet to "7 mm".
2. In the [Finishing: Fold] group on the [Adjustment Settings for Operators] menu, select
0809: [Letter Fold-in Position 1: 1 sheet Fold].
CEZ592
Multi-Folding Unit
163