Advertisement
Installation Procedure > In the case iR-ADV C9280 PRO/C9270 PRO Series, iR-ADV C7280/C7270/C7260 Series > Installing the PS Unit
5) Connect the Power Cord and the Shield Ethernet Cable to the PS Unit.
CAUTION:
• Use the correct power code to mach the location/area of installation. Make sure not
to leave unused power code at the site.
• Be sure to use the network cable with Category 5e or higher. In addition, a sealed
type (STP cable) is recommended. When using the non-sealed type (UTP cable),
it may influence the surrounding electronic equipments via network cable.
x2
Power Cord
Shield Ethernet Cable
Installation Procedure > In the case iR-ADV C9280 PRO/C9270 PRO Series, iR-ADV C7280/C7270/C7260 Series > Installing the PS Unit
6) Plug the power cord into an outlet.
7) Turn the PS Unit power on, then turn the host machine power switch on.
8) When the message "Turn the host machine power off and back on" appears on the touch
panel, turn the host machine power switch off.
NOTE:
On PS Unit, it automatically restarts only at the first time connection. It takes approx. 5
minutes until it is ready for use.
Do not press the buttons on the PS Unit until it is ready for use.
9) Turn the host machine power switch on again.
F-1-35
12
12
Advertisement
