Advertisement
Installation Procedure > In the case iR-ADV C5255/C5250/C5240/C5235 Series > Installing the PS Unit
10)
Install Main Controller PCB 2.
CAUTION:
• Lift the grip and insert the Main Controller PCB 2. When it touches the end, tilt the
grip and install it with 2 screws.
• Make sure to tilt the grip slowly on both sides simultaneously.
• Check that the Main Controller PCB 2 is installed properly.
11)
Install the FAX Cable (if the FAX is installed).
12)
Install the Left Rear Sub Cover. (1 Screw)
13)
Install the Reader Communication Cable (if the Reader is installed).
14)
Connect the Interface Cable to the installed Open I/F PCB.
Installation Procedure > In the case iR-ADV C5255/C5250/C5240/C5235 Series > Installing the PS Unit
x2
Grip
F-1-14
F-1-15
15)
Cut off [A] part of the Left Rear Cover with nippers.
CAUTION:
Be sure to remove adequately so that there is no burr.
16)
Install the Left Reader Cover. (2 Screws, 2 Rubber Caps)
■ Installing the PS Unit
1) Install the PS Unit to the left side of the host machine.
6
[A]
F-1-16
F-1-17
6
Advertisement
