Sftp Configuration Example - H3C S3600 Series Operation Manual

Operation Manual – SSH Terminal Service
H3C S3600 Series Ethernet Switches-Release 1510
Table 2-9 Display help information about an SFTP client command
Enter system view
Enter SFTP client view
Display help information about
one or all SFTP client commands
VI. Specifying a source IP address or source interface for the SFTP client
You can use the command here to specify a source IP address or source interface for
the SFTP client, thus enhancing traffic manageability.
Table 2-10 Specify a source IP address/interface for the SFTP client
Enter system view
Specify a source IP address
for the SFTP client
Specify a source interface for
the SFTP client
Display the current source IP
address or the IP address of
the source interface specified
for the SFTP client

2.1.4 SFTP Configuration Example

I. Network requirements
As shown in Figure 2-1: an SSH connection is established between SwitchA and
SwitchB. SwitchA, an SFTP client, uses the username client001 and password abc to
login to SwitchB for file management and file transfer.
II. Network diagram
SwitchB
SFTP Server
Figure 2-1 Network diagram for SFTP configuration
Operation
Operation
Vlan-interface
192.168.0.2/2
Vlan-interface1
192.168.0.1/24
Command
system-view
sftp { host-ip | host-name }
help [ all | command-name ]
Command
system-view
sftp source-ip ip-address
sftp source-interface
interface-type
interface-number
display sftp source-ip
SwitchA
1
SFTP Client
4
2-6
Chapter 2 SFTP Service
Description
—
—
Optional
Description
—
Optional
Optional
Optional
You can execute
this command in
any view.