H3C S3600 Series Operation Manual page 21

Operation Manual – SSH Terminal Service
H3C S3600 Series Ethernet Switches-Release 1510
I. configure the device as an SSH client that supports first authentication
Table 1-10 Configure the device as an SSH client that supports first authentication
Operation
Enter system view
Enable the client to
run
authentication
Start the client to
establish
connection with an
SSH server
II. configure the device as an SSH client that does not support first
authentication
Table 1-11 Configure the device as an SSH client that does not support first
authentication
Enter system view
Disable the SSH client
from
authentication
SSH
accessed
Enter public key view
Enter public key edit view
Configure the public key
for the server
system-view
initial ssh client first-time enable
ssh2 { host-ip | host-name }
[ port-num
{
dh_exchange_group
prefer_ctos_cipher { des |
a
aes128 } | prefer_stoc_cipher
{ des
prefer_ctos_hmac { sha1 |
sha1_96 | md5 | md5_96 } |
prefer_stoc_hmac { sha1 |
sha1_96 | md5 | md5_96 } ] *
Operation
system-view
performing first
undo
for the
first-time
server to be
rsa
keyname
public-key-code begin
Input
directly
Command
] [ prefer_kex
dh_group1 |
} |
| aes128 } |
Command
ssh client
peer-public-key
the public key
1-20
Chapter 1 SSH Terminal Service
Description
—
Optional
By default, the client is
enabled to run
authentication.
Required
In this command, you can
also specify the preferred
key exchange algorithm,
encryption algorithms and
HMAC algorithms
between the server and
client.
HMAC: Hash-based
message authentication
code
Description
—
Required
By default, the SSH client
performs
authentication.
Optional
—
—
The input public key string
can contain spaces and
enters. The public key to
be configured must be a
hexadecimal string coded
in the public format.
initial
first